|
|
RRS RACK INSTALL PICTURES AND INSTRUCTION GUIDE. Continued
Factory steering box frame holes are used to mount Left rack bracket and drag link holes are used for the right rack brackets.
Left rack bracket installed.
You must drill 2 holes through the outer frame lip on both left and right sides of the car, after brackets are installed.
Install the reinforcement plate and bolts to the outer frame lip.
You are now ready to install the rack into the mounting brackets and tighten it all down.
View of Right side rack mounting bracket with the RRS rack installed.
View of Left rack mounting bracket with the RRS rack installed
View of right bracket from wheel well.
Now connect both left and right outer tie rod ends to the inner tie rods. When the car is on the ground you can do a rough alignment. Remember take your car to get an wheel alignment
Install your column into your car using the original dash brackets. Center the RRS rack, slide the shaft on the the RRS rack spine. Check and tighten all bolts, center your steering wheel. Check to make you followed all the RRS install instructions supplied in the install book. These pictures we have supplied and instructions are only to be used as a guide so you know what to except when you are installing your new RRS rack system.
View of steering shaft looking down into the engine compartment on left side.
|
|
HOME
ABOUT US
RETURN POLICY
CUSTOM AIRBRUSH
CURRENT PROJECTS
CONTACT |